标准编号：ISO 4647:2010
中文名称：硫化橡胶 与纺织窜线静态粘合强度的测定 H-抽出试验
英文名称：Rubber, vulcanized — Determination of static adhesion to textile cord — H-pull test
发布日期：2010-10
标准范围
WARNING — Persons using this International Standard should be familiar with normal laboratorypractice. This standard does not purport to address all of the safety problems, if any, associated withits use. It is the responsibility of the user to establish appropriate safety and health practices and toensure compliance with any national regulatory conditions.CAUTION — Certain procedures specified in this International Standard may involve the use orgeneration of substances, or the generation of waste, that could constitute a local environmentalhazard. Reference should be made to appropriate documentation on safe handling and disposal after use.This International Standard specifies a method for the determination of the static adhesion of textile cord tovulcanized rubber using the H-pull test. It is applicable to cords made from natural or man-made fibres.The property levels obtained with this method are affected considerably by the history of the cord and therubber compound. The method yields data, however, on which a judgement as to the service quality of thematerial can be based.The method is primarily intended for use with tyre cord. However, it can be applied, if desired, to similar cordsfor use in other rubber products, but it is limited to cords of linear density not exceeding 800 mg/m (tex).
立即下载标准文件