标准编号：ISO 4437-5:2014
中文名称：燃气供应用塑料管道系统 聚乙烯（PE） 第5部分：系统的适用性
英文名称：Plastics piping systems for the supply of gaseous fuels - Polyethylene (PE) — Part 5: Fitness for purpose of the system
发布日期：2014-01
标准范围
This part of ISO 4437 specifies the requirements of fitness for purpose of the polyethylene (PE) piping system to be used for the supply of gaseous fuels.It specifies the definitions of electrofusion, socket fusion, butt fusion, and mechanical joints.It specifies the method of preparation of test piece joints and the tests to be carried out on these joints for assessing the fitness for purpose of the system under normal and extreme conditions.It specifies the test parameters for the test methods referred to in this part of ISO 4437.In conjunction with ISO 4437-1, ISO 4437-2, ISO 4437-3, and ISO 4437-4, it is applicable to PE pipes, fittings, valves, their joints, and joints with components of PE and other materials intended to be used under the following conditions:a) the maximum operating pressure (MOP) is based on the design stress, determined from the compound minimum required strength (MRS) divided by the C factor, and taking into account rapid crack propagation (RCP) requirements;b) a temperature of 20 °C as reference temperature for the design basis.NOTE 1 For other operating temperatures, derating coefficients are given in Annex A.NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installationpractices or codes
立即下载标准文件