标准编号：ISO/ASTM 51631:2013
中文名称：电子束剂量测量和常规剂量测定系统校准用量热计剂量测定系统的实用规程
英文名称：Practice for use of calorimetric dosimetry systems for electron beam dose measurements and dosimetery system calibrations
发布日期：2013-04
标准范围
1.1 This practice covers the preparation and use of semiadiabatic calorimetric dosimetry systems for measurement of absorbed dose and for calibration of routine dosimetry systems when irradiated with electrons for radiation processing applications. The calorimeters are either transported by a conveyor past a scanned electron beam or are stationary in a broadened beam.1.2 This document is one of a set of standards that provides recommendations for properly implementing dosimetry in radiation processing, and describes a means of achieving compliance with the requirements ofASTM Practice E2628 fora calorimetric dosimetry system. It is intended to be read in conjunction with ASTM Practice E2628.1.3 The calorimeters described in this practice are classified as Type II dosimeters on the basis of the complex effect of influence quantities. See ASTM Practice E2628.1.4 This practice applies to electron beams in the energy range from 1.5 to 12 MeV.1.5 The absorbed dose range depends on the absorbing material and the irradiation and measurement conditions. Minimum dose is approximately 100 Gy and maximum dose is approximately 50 kGy.1.6 The average absorbed-dose rate range shall generally be greater than 10 Gy·s-1.1.7 The temperature range for use of these calorimetric dosimetry systems depends on the thermal resistance of the materials, on the calibrated range of the temperature sensor, and on the sensitivity of the measurement device.1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
标准预览图
立即下载标准文件