标准编号：ISO 5001:2007
中文名称：上透明釉用冷轧碳素薄钢板
英文名称：Cold-reduced carbon steel sheet for vitreous enamelling
发布日期：2007-07
标准范围
This International Standard applies to cold-reduced carbon steel sheet of commercial and drawingqualities for vitreous enamelling, where the surface of the sheet and chemical composition of the base metalare of prime importance.Sheet for vitreous enamelling is produced in thicknesses of 0,35 mm and thicker (commonly up to3 mm) and in widths of 600 mm and wider in coils and cut lengths. Sheet for vitreous enamelling less than600 mm wide may be slit from wide sheet and will be considered sheet.Commercial-quality sheet (VE01) is intended for general fabricating purposes where sheet is used inthe flat form, or for bending or moderate forming.Drawing-quality sheet (VE02, VE03, VE04 and VE05) is intended for drawing and severe forming. It isfurnished to all requirements of this International Standard or, by agreement when ordered, to fabricate anidentified part, in which case the mechanical properties of Table 1 do not apply. If strain ageing is to beminimized, grade VE04 or VE05 should be specified.Drawing qualities are identified as follows:VE02 — drawing quality;VE03 — deep-drawing quality;VE04 — deep-drawing quality aluminium-killed (see 4.7);VE05 — extra-deep-drawing quality (stabilized interstitial-free).The designations in 1.3 and 1.4 include the qualities of sheet steel for vitreous enamelling. Thedesignation VE represents “vitreous enamelling” similar to CR “cold reduced”. The numbers 01, 02, 03, 04 and05 are common to other standards, indicating the qualities of commercial, drawing, deep-drawing, deepdrawingaluminium-killed and extra-deep-drawing stabilized interstitial-free.
标准预览图
立即下载标准文件