标准编号：ISO 7432:2018
中文名称：玻璃增强热固性塑料（GRP）管和配件 带弹性密封件的锁接套和插口接头（包括双套接接头）设计的试验方法
英文名称：Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Test methods to prove the design of locked socket-and-spigot joints, including double-socket joints, with elastomeric seals
发布日期：2018-09
标准范围
This document specifies methods of test for joints with a locked socket and spigot, including double-
socket joints, and with elastomeric seals, for buried and above ground glass-reinforced thermosetting
plastics (GRP) piping systems. It covers methods of test for leaktightness and resistance to damage of the
joint only, when subjected to specified combinations of angular movement, compression (deformation)
perpendicular to the pipe axis and internal pressure. It assumes that the joint will be exposed to the
effects of hydrostatic end thrust.
This document is applicable to joints for either pressure or non-pressure applications. The tests are
suitable for the evaluation of joints intended for applications in which the liquids are conveyed at
temperatures specified in the referring standards.
The joints tested in accordance with this document are subjected to conditions which measure their
ability to function and thereby prove the design of the joint, especially for type test purposes. The joint
is only qualified according to the test sequences and configurations detailed in this document.
With the exception of the bending test (see 9.5), the test procedures are applicable to joints for pipes
and fittings of all nominal sizes. If not otherwise agreed between the manufacturer and the customer,
the bending test detailed in 9.5 is applicable to joints with pipes and fittings up to and including DN 600.
The test procedures in this document are damaging to the test piece, which will not be suitable for
reuse after these tests. The test procedure is intended to be applied for type testing purposes.
This document is applicable only to the joint and specifies methods of test to prove its design.
立即下载标准文件