标准编号：ISO 6336-3:2006
中文名称：正齿轮和斜齿轮承载能力的计算 第3部分：轮齿抗弯强度的计算
英文名称：Calculation of load capacity of spur and helical gears — Part 3: Calculation of tooth bending strength
发布日期：2006-09
标准范围
This part of ISO 6336 specifies the fundamental formulae for use in tooth bending stress calculations forinvolute external or internal spur and helical gears with a rim thickness sR > 0,5 ht for external gears andsR > 1,75 mn for internal gears. In service, internal gears can experience failure modes other than toothbending fatigue, i.e. fractures starting at the root diameter and progressing radially outward. This part ofISO 6336 does not provide adequate safety against failure modes other than tooth bending fatigue. All loadinfluences on tooth stress are included in so far as they are the result of loads transmitted by the gears and inso far as they can be evaluated quantitatively.The given formulae are valid for spur and helical gears with tooth profiles in accordance with the basic rackstandardized in ISO 53. They may also be used for teeth conjugate to other basic racks if the virtual contactratio εαn is less than 2,5.The load capacity determined on the basis of permissible bending stress is termed “tooth bending strength”.The results are in good agreement with other methods for the range, as indicated in the scope of ISO 6336-1.
立即下载标准文件