标准编号：ISO 19840:2004
中文名称：油漆和清漆 钢结构腐蚀保护用防护漆系统 在粗糙的表面上干（薄）膜的厚度测定和和验受标准
英文名称：Paints and varnishes — Corrosion protection of steel structures by protective paint systems — Measurement of, and acceptance criteria for, the thickness of dry films on rough surfaces
发布日期：2004-11
标准范围
This International Standard specifies a procedure for the verification of dry film thickness against nominal dry film thickness on rough surfaces, including the adjustment of the instruments used, the definition of inspection areas, sampling plans, measurement methods and acceptance/rejection criteria.For the purposes of this standard, any specified thickness is taken to be nominal as defined in ISO 12944-5 and the dry film thickness is the typical thickness above the peaks of the surface profile.The procedure described in this International Standard is based on the use of instruments of the permanent magnet and inductive magnet type. Instruments are adjusted to zero and a known thickness on a smooth surface.Measurements taken on a coating on a roughened steel substrate will therefore be higher than the actual value above the peaks of the profile. The thickness of the dry film above the peaks of the profile is defined as the instrument reading minus an appropriate correction value.The dry film thickness is obtained by using the appropriate correction value applied to readings based on adjustment on a smooth, flat, steel surface.Where individual readings, based on adjustment on a smooth, flat steel surface without the use of correction values, are specified or agreed, it is important to recognise that this method does not conform with this International Standard.This standard is applicable if the nominal dry film thickness is 40 μm or greater.NOTE If the nominal thickness is less than the surface roughness of the substrate the uncertainty of the measurement will increase.
立即下载标准文件