ISO 13232-4:2005 摩托车 摩托车驾驶员冲击保护设备用试验和分析程序 第4部分： 被测变量，仪器仪表和测量程序

标准编号：ISO 13232-4:2005

中文名称：摩托车 摩托车驾驶员冲击保护设备用试验和分析程序 第4部分： 被测变量，仪器仪表和测量程序

英文名称：Motorcycles — Test and analysis procedures for research evaluation of rider crash protective devices fitted to motorcycles — Part 4: Variables to be measured, instrumentation and measurement procedure

发布日期：2005-12

标准范围

This part of ISO 13232 specifies requirements for the:-- repeatability and reproducibility of the dynamic measurement procedures for the motorcycle, the opposingvehicle, and the dummy; and-- dummy instrumentation.ISO 13232 specifies the minimum requirements for research into the feasibility of protective devices fitted tomotorcycles, which are intended to protect the rider in the event of a collision.ISO 13232 is applicable to impact tests involving:-- two-wheeled motorcycles;-- the specified type of opposing vehicle;-- either a stationary and a moving vehicle or two moving vehicles;-- for any moving vehicle, a steady speed and straight-line motion immediately prior to impact;-- one helmeted dummy in a normal seating position on an upright motorcycle;-- the measurement of the potential for specified types of injury by body region;-- evaluation of the results of paired impact tests (i.e. comparisons between motorcycles fitted and not fitted withthe proposed devices).ISO 13232 does not apply to testing for regulatory or legislative purposes.

标准预览图