标准编号:ISO 18831:2016
中文名称:服装 数码配件 虚拟服装的属性
英文名称:Clothing — Digital fittings — Attributes of virtual garments
发布日期:2016-04
标准范围
This International Standard specifies the procedures for the preparation of test pieces from refractorymaterials by wet gunning at ambient temperatures. The test pieces are for the determination ofproperties on wet-gunned products prepared under either “standard conditions” (as required forquality assurance or product development) or “site conditions”. In the case of “site conditions”, thepurpose of the testing is to establish the properties pertaining to a given installation or a given set ofinstallation conditions. In this case, the gunned panel is obtained during the on-site installation. Suchparameters as activator addition (type, amount, method of addition), conveying pressure and curingconditions (temperature, orientation of the panel) applying during the preparation of the panel are asnear as possible to the same parameters pertaining to the site installation.This procedure applies to refractory materials that can be transported through a gunning hose afterhaving been mixed with the total water requirement for material placement. The consistency of thesematerials (see 7.5) is typically such that they would be suitable for placement by casting were they notto be transported through the gunning hose and applied by spraying.Refractory materials that are pneumatically conveyed in the “dry” state through a gunning hose, evenafter mixing with a portion of the total water requirement (the bulk of the water being added at thenozzle) are dealt with in ISO 20182.This International Standard does not apply to the gunning of plastic refractory materials (refer toISO 1927-1).