标准编号：ISO 22915-1:2016
中文名称：工业车辆 稳定性的验证 第1部分：总则
英文名称：Industrial trucks — Verification of stability — Part 1: General
发布日期：2016-01
标准范围
The ISO 22915 series deals with the safety of industrial trucks, as defined in ISO 5053-1, relative totheir stability and the verification of that stability. For the purposes of ISO 22915, industrial trucksare wheeled, self-propelled, or pedestrian-propelled vehicles excepting those running on rails. They areeither operator-controlled or driverless, and are designed to carry, tow, push, lift, stack or tier in racks.This part of ISO 22915 specifies basic test criteria and requirements for verifying the stability ofindustrial trucks, hereafter referred to as trucks.It applies to the following truck types and special conditions:a) counterbalanced trucks with mast as specified in ISO 22915-2;b) reach and straddle trucks as specified in ISO 22915-3;c) pallet stackers, double stackers, and order-picking trucks with operator position elevating up toand including 1 200 mm lift height as specified in ISO 22915-4;d) single-side-loading trucks as specified in ISO 22915-5;e) bidirectional and multidirectional trucks as specified in ISO 22915-7;f) additional stability test for trucks operating in special conditions of stacking with the mast tiltedforward as specified in ISO 22915-8;g) counterbalanced trucks with mast handling freight containers of 6 m (20 ft) length and longer asspecified in ISO 22915-9;h) additional stability test for trucks operating in special conditions with the load substantiallylaterally displaced by powered devices as specified in ISO 22915-10;i) industrial variable-reach trucks as specified in ISO 22915-11;j) industrial variable-reach trucks handling freight containers of 6 m (20 ft) length and longer asspecified in ISO 22915-12;k) rough-terrain variable-reach trucks as specified in ISO 22915-14;l) counterbalanced trucks with articulated steering as specified in ISO 22915-15;m) pedestrian-propelled trucks as specified in ISO 22915-16;n) additional stability test for trucks operating in the special condition of offset load, offset determinedby utilization as specified in ISO 22915-20;o) order-picking trucks with operator position elevating above 1 200 mm as specified in ISO 22915-21.It also applies to trucks operating under the same conditions when equipped with load-handlingattachments.This part of ISO 22915 does not apply to the following:— trucks handling suspended loads which may swing freely;— low-lift trucks with lift height up to and including 500 mm.
标准预览图
立即下载标准文件