标准编号：ISO 23529:2010
中文名称：橡胶 物理试验方法试样制备和调节通用程序
英文名称：Rubber — General procedures for preparing and conditioning test pieces for physical test methods
发布日期：2010-10
标准范围
WARNING — Persons using this International Standard should be familiar with normal laboratorypractice. This standard does not purport to address all of the safety problems, if any, associated withits use. It is the responsibility of the user to establish appropriate safety and health practices and toensure compliance with any national regulatory conditions.CAUTION — Certain procedures specified in this International Standard can involve the use orgeneration of substances, or the generation of waste, that could constitute a local environmentalhazard. Reference should be made to appropriate documentation on safe handling and disposal after use.This International Standard specifies general procedures for the preparation, measurement, marking, storage,and conditioning of rubber test pieces for use in physical tests specified in other International Standards, andthe preferred conditions to be used during the tests. Special conditions, applicable to a particular test ormaterial or simulating a particular climatic environment, are not included, nor are special requirements fortesting whole products.This International Standard also specifies the requirements for the time interval to be observed betweenforming and testing of rubber test pieces and products. Such requirements are necessary to obtainreproducible test results and to minimize disagreements between customer and supplier.
立即下载标准文件