ISO 5725-4:2020 测量方法和结果的精确度（真实和精确） 第4部分：使用标准测量方法的精度测定基本方法

标准编号：ISO 5725-4:2020

中文名称：测量方法和结果的精确度（真实和精确） 第4部分：使用标准测量方法的精度测定基本方法

英文名称：Accuracy (trueness and precision) of measurement methods and results — Part 4: Basic methods for the determination of the trueness of a standard measurement method

发布日期：2020-03

标准范围

1.1 This document
— specifies basic methods for estimating the bias of a measurement method and the laboratory bias
when a measurement method is applied;
— provides a practical approach of a basic method for routine use in estimating the bias of measurement
methods and laboratory bias;
— provides a brief guidance to all personnel concerned with designing, performing or analysing the
results of the measurements for estimating bias.
1.2 It is concerned exclusively with measurement methods which yield measurements on a continuous
scale and give a single value as the measurement result, although the single value can be the outcome of a
calculation from a set of observations.
1.3 This document applies when the measurement method has been standardized and all
measurements are carried out according to that measurement method.
NOTE In ISO/IEC Guide 99:2007(VIM), “measurement procedure” (2.6) is an analogous term related to the
term “measurement method” used in this document.
1.4 This document applies only if an accepted reference value can be established to substitute the true
value by using the value, for example:
— of a suitable reference material;
— of a suitable measurement standard;
— referring to a suitable measurement method;
— of a suitable prepared known sample.
1.5 This document applies only to the cases where it is sufficient to estimate bias on one property at
a time. It is not applicable if the bias in the measurement of one property is affected by the level of any
other property (i.e. it does not consider interferences by any influencing quantity). Comparison of the
trueness of two-measurement methods is considered in ISO 5725-6.

标准预览图