标准编号：ISO/IEC 7811-1:2014
中文名称：识别卡 记录技术 第1部分：压印
英文名称：Identification cards — Recording technique — Part 1: Embossing
发布日期：2014-09
标准范围
This part of ISO/IEC 7811 is one of a series of International Standards describing the parameters foridentification cards as defined in the definitions clause and the use of such cards for internationalinterchange.This part of ISO/IEC 7811 specifies requirements for embossed characters on identification cards.The embossed characters are intended for transfer of data either by use of imprinters or by visual ormachine reading. It takes into consideration both human and machine aspects and states minimumrequirements.It is the purpose of this International Standards to provide criteria to which cards shall perform. Noconsideration is given within these International Standards to the amount of use, if any, experienced bythe card prior to test. Failure to conform to specified criteria should be negotiated between the involvedparties.ISO/IEC 10373-1 specifies the test procedures used to check cards against the parameters specified inthis part of ISO/IEC 7811.NOTE 1 Numeric values in the SI and/or Imperial measurement system in this part of ISO/IEC 7811 mighthave been rounded off and therefore are consistent with, but not exactly equal to, each other. Either system canbe used, but the two is not intended to be intermixed or reconverted. The original design was made using theImperial measurement systemNOTE 2 TIM (Tactile Identifier Mark) defined by ISO/IEC 7811-9 can be located in the name and address areaof this part of ISO/IEC 7811. The layout of embossed characters in this area is not intended to interfere with TIM.
标准预览图
立即下载标准文件