ISO/TR 17243-3:2020 机床主轴 通过测量主轴箱对机床主轴振动的评价 第3部分：带运行速度在600 r/min到12 000 r/min之间滚动轴承的齿轮驱动主轴

标准编号：ISO/TR 17243-3:2020

中文名称：机床主轴 通过测量主轴箱对机床主轴振动的评价 第3部分：带运行速度在600 r/min到12 000 r/min之间滚动轴承的齿轮驱动主轴

英文名称：Machine tool spindles — Evaluation of machine tool spindle vibrations by measurements on spindle housing — Part 3: Gear-driven spindles with rolling bearings operating at speeds between 600 r/min and

发布日期：2020-02

标准范围

This document provides information on how to assess the severity of machine tool spindle vibrations
measured on the spindle housing. It gives specific guidance for assessing the severity of vibration
measured on the spindle housing at customer sites or at the machine tool manufacturer’s test facilities.
Its vibration criteria apply to gear-driven spindles intended for stationary machine tools with nominal
operating speeds between 600 r/min and 12 000 r/min.
It is applicable to those spindles of the rolling bearing types only, to spindles assembled on metal cutting machine tools, and for testing, periodic verification, and continuous monitoring.
It does not address:
— geometrical accuracy of axes of rotation (see ISO 230-7);
— unacceptable cutting performance with regards to surface finish and accuracy;
— vibration severity issues of machine tool spindles operating at speeds below 600 r/min or exceeding 12 000 r/min (due to lack of supporting vibration data); or
— frequency domain analyses such as fast Fourier transform (FFT) analyses, envelope analyses or
other similar techniques.
Annex A presents an introduction to alternative bearing condition assessment techniques.

标准预览图